Network Menu - Wired Lan Menu; Network Menu - Projector Control Menu - Epson EH-QS100B User Manual

Projector Network Settings - Network Menu

Network Menu - Wired LAN Menu

Settings on the Wired LAN menu let you select the wired LAN settings.
Setting Options
IP Settings DHCP
IP Address
Subnet Mask
Gateway Address
DNS Server 1 Various IP
addresses
DNS Server 2
IPv6 On
Off
Description
Set DHCP to On if your network assigns
addresses automatically; set to Off to
manually enter the network's IP Address,
Subnet Mask, and Gateway Address
using 0 to 255 for each address field.
Do not use these addresses: 0.0.0.0,
127.x.x.x, 192.0.2.x or 224.0.0.0 through
255.255.255.255 (where x is a number
from 0 to 255) for IP Address,
255.255.255.255 or 0.0.0.0 through
254.255.255.255 for Subnet Mask, and
0.0.0.0, 127.x.x.x or 224.0.0.0 through
255.255.255.255 for Gateway Address.
Enter the IP address for the DNS server,
using 0 to 255 for each address field. The
DNS server resolves the host name. You
cannot use the following IP addresses:
127.x.x.x (where x is a number from 0 to
255).
When these settings are not set
and remain as 0.0.0.0, DNS server
information is acquired using DHCP.
After acquiring the information, the
values remain as 0.0.0.0.
Set to On if you want to connect the
projector to the network using IPv6.
IPv6 is supported to monitor and control
the projector over a network using Epson
Web Control and PJLink.
Setting Options
Auto Configuration On
Off
Use Temporary On
Address
Off
IP Address Display On
Off

Network Menu - Projector Control Menu

Settings on the Projector Control menu let you select settings for controlling
the projector over a network.
Setting Options
Command Protected
Communication
Compatible
Web API Settings Web API
Description
Set to On to assign addresses
automatically according to the Router
Advertisement.
Set to On if you want to use a temporary
IPv6 address.
Set to On to display the IP address on the
network information screen and Home
screen.
Description
Selects the authentication method for
command communication.
When using Command Communication,
set the Monitor Password or the Web
Control Password.
Network > Network Settings > Web
s
Control Password
Set to Compatible when performing
plain text authentication using the
Monitor Password (up to 16
alphanumeric characters long).
Select Compatible when monitoring
projectors with a switcher and a system
controller.
Select On to enable the Web API
function.
132