Solving Projector Or Remote Control Operation Problems; Solutions To Projector Power Or Shut-Off Problems; Solutions To Problems With The Remote Control - Epson EH-QS100B User Manual

Solving Projector or Remote Control Operation Problems

Check the solutions in these sections if you have problems operating the
projector or remote control.
Related Links
g
• "Solutions to Projector Power or Shut-Off Problems"
• "Solutions to Problems with the Remote Control"
• "Solutions to Password Problems"
• "Solution When "The Battery that Saves Your Clock Settings is Running Low"
Message Appears" p.166

Solutions to Projector Power or Shut-Off Problems

If the projector does not turn on when you press the power button or it turns off
unexpectedly, try the following solutions:
• Make sure the power cord is securely connected to the projector and to a
working electrical outlet.
• If the power button on the remote control does not turn on the projector,
check its batteries and make sure at least one of the remote receivers are
available in the Remote Receiver setting in the projector's Installation menu.
• The projector's buttons may be locked for security. Unlock the buttons
from the Control Panel Lock or Child Lock setting in the projector's
Management menu, or use the remote control to turn on the projector.
• If the projector's light source turns off unexpectedly, it may have entered
sleep mode after a period of inactivity. Perform any operation to wake the
projector. To turn off sleep mode, set the Sleep Mode setting to Off in the
projector's Operation menu.
• If the projector's light source turns off and the status indicator is lit, the
projector has overheated and turned off.
• The cooling fans may run in standby status depending on the projector
settings. Also, when the projector wakes from standby status, the fans may
cause an unexpected noise. This is not a malfunction.
p.165
p.165
p.166
• The power cord may be defective. Disconnect the cord and contact Epson for
help.
Related Links
g
• "Unlocking the Projector's Buttons"
• "Projector Administration Settings - Management Menu"
• "Projector Feature Settings - Operation Menu"
• "Projector Installation Settings - Installation Menu"

Solutions to Problems with the Remote Control

If the projector does not respond to remote control commands, try the following
solutions:
• Check that the remote control batteries are installed correctly and have
power. If necessary, replace the batteries.
• Make sure you are operating the remote control within the reception angle
and range of the projector.
• Make sure the projector is not warming up or shutting down.
• Check to see if a button on the remote control is stuck down, causing it to
enter sleep mode. Release the button to wake the remote control up.
• Strong fluorescent lighting, direct sunlight, or infrared device signals may be
interfering with the projector's remote receivers. Dim the lights or move the
projector away from the sun or interfering equipment.
• Make sure at least one of the remote receivers are available in the Remote
Receiver setting in the projector's Installation menu.
• If the Remote Receiver setting is disabled, hold down the [Menu] button on
the remote control for at least 15 seconds to reset the setting to its default.
• If you lose the remote control, you can order another one from Epson.
Related Links
g
• "Installing Batteries in the Remote Control"
• "Remote Control Operation"
p.36
p.96
p.129
p.127
p.124
p.35
165