Batch Setup Error Notification - Epson EH-QS100B User Manual

Copying Menu Settings Between Projectors (Batch Setup)
f
Eject the USB device (Windows) or drag the removable disk icon to the
Trash (Mac).
g
Disconnect the USB cable.
The projector turns off.
h
Disconnect the power cord from the projector to which you want to copy
settings, and check that all of the projector's indicators have turned off.
i
Connect the USB cable to the computer's USB port and to the projector's
USB-B port.
j
Hold down the [Menu] button on the remote control or the control panel
and connect the power cord to the projector.
k
When all of the projector's indicators turn on, release the [Menu] button.
The computer recognizes the projector as a removable disk.
l
Copy the batch setup file (PJCONFDATA.bin) that you saved to your
computer to the top level folder of the removable disk.
Do not copy any files or folders other than the batch setup file to the
removable disk.
m
Eject the USB device (Windows) or drag the removable disk icon to the
Trash (Mac).
n
Disconnect the USB cable.
When all of the indicators start flashing, the settings are being written.
When writing is finished, the projector turns off.
Caution
Do not disconnect the power cord from the projector while the file is being
written. If the power cord is disconnected, the projector may not start
correctly.
Related Links
g
• "Batch Setup Error Notification"

Batch Setup Error Notification

The status indicator on the projector notifies you if an error occurs during
a batch setup operation. Check the status of the indicator and follow the
instructions in this table.
Indicator status Problem and solutions
Orange - flashing fast The batch setup file may be corrupt, or the USB flash
drive may not be connected correctly.
Disconnect the USB flash drive, unplug and then plug in
the projector's power cord, and then try again.
p.139
139