Landesk Client Manager - NEC POWERMATE ENTERPRISE NETPC Service Manual

1. Write down the Setup parameters currently set on the system.
2. Turn off the system.
Insert the flash diskette into drive A and turn on the system.
3.
When the flash upgrade menu appears, choose "Update Flash Memory Area from
4.
a file."
When the menu asks you to enter a path/filename, use the arrow keys to select the
5.
".bio" file and press
6. The utility asks for a confirmation that you want to load the new flash into
memory. Select "Continue with Programming."
7. After the upgrade completes, remove the upgrade diskette.
Reboot the system and start the Setup program. Press
8.
defaults. Then, use the copy of the Setup selections you made at the beginning of
this procedure to set the parameters.

LANDESK CLIENT MANAGER

LANDesk Client Manager (LDCM) is a software program available on the NEC Select
Install CD. LDCM uses the Desktop Management Interface (DMI) standard to manage
components (network interface cards, memory, software applications) within a Client
(local) or remote (workstation) PC system. It provides features for managing the resources
of a local PC and can be used by system administrators to manage groups of computer
systems.
See "NEC Select Install CD" for instructions on installing LANDesk Client Manager on the
NetPC hard disk.
With Client Manager you can perform the following tasks:
T
review system inventory of workstation hardware and software components
T
view DMI-compliant component information
T
troubleshoot
T
receive notice of system events (for example, if the system is running low on
memory, you are notified of the potential problem)
NOTE: The following procedure requires that
you connect an external diskette drive (with a
separate power supply) to the diskette drive
connector on the riser card.
.
Enter
Technical Information
to reset the BIOS
F9
2-25