Replacement; Battery - NEC POWERMATE ENTERPRISE NETPC Service Manual

Replacement

To replace the front bezel, proceed as follows:
1. Complete steps 1 through 6 in the previous subsection.
2. Insert the bottom edge of the front bezel into the bottom cover.
Tilt the front bezel up until the two locking tabs pop into place in the chassis slots.
3.

Battery

This subsection describes how to replace the CMOS battery.
To remove the battery, proceed as follows:
Turn off the system and disconnect the power cord and all peripheral cables
1.
connected to the system.
2. Remove the system unit top cover (see "System Unit Top Cover").
3. Remove the front bezel (see "Front Bezel").
Figure 5-3 Removing the Front Bezel
WARNING: The battery can explode if it is
incorrectly replaced. Replace the battery only
with the same or equivalent type recommended
by the equipment manufacturer. Discard used
batteries according to manufacturer's
instructions.
Disassembly and Reassembly 5-7