Installing An Expansion Board - NEC POWERMATE ENTERPRISE NETPC Service Manual

Installing an Expansion Board

To install an expansion board in the system, use the following steps.
Remove the system unit cover (see "Removing the System Unit Cover").
1.
2. Open the system chassis (see "Opening the System Chassis").
3. Follow any preinstallation instructions that come with the expansion board (see
the expansion board documentation).
4. Remove the screw securing the expansion slot cover and retaining bracket (see
Figure 3-8, A). Set the screw and bracket aside for use in securing the expansion
board.
5. Remove the slot cover (see Figure 3-8, B). Save it to cover the slot again in case
the expansion board is removed.
CAUTION: A slot cover can damage the system
board or any option board if it falls into the
system. Take care to keep the slot cover from
falling when removing the screw.
If the slot cover does fall into the unit, remove it
before replacing the cover.
Option Installation 3-9