Table of Contents
Advertisement
Figure 3-12 Removing the Hard Disk Screws and Cables
5.
Remove the hard disk from the chassis.
6.
Install the hard disk upgrade in the chassis using the four screws.
7.
Connect the power and signal cables to the hard disk upgrade.
NOTE: Make sure the other end of the hard
disk data cable is securely connected to the IDE
connector on the riser card (see the following
figure).
Option Installation
3-17
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the POWERMATE ENTERPRISE NETPC and is the answer not in the manual?
Questions and answers