Emi Shield; Removal - NEC POWERMATE ENTERPRISE NETPC Service Manual

5-8 Disassembly and Reassembly
4. Separate the two halves of the chassis (see "Opening the System Chassis" in
Section 3).
Remove the battery with a small straight-blade screwdriver (see Figure 5-4).
5.
6. Replace the battery with a Panasonic CR2032 or equivalent type.
Reattach the top and bottom halves of the chassis (see "Closing the System
7.
Chassis" in Section 3).
Replace the front bezel (see "Front Bezel").
8.
Replace the system unit top cover (see "System Unit Top Cover").
9.
10. Conect the power cord and monitor and peripheral cables.

EMI Shield

This subsection describes how to remove and replace the EMI shield.

Removal

To remove the EMI shield, proceed as follows:
1. Turn off the system and disconnect the power cord and all peripheral cables
connected to the system.
Remove the system unit top cover (see "System Unit Top Cover").
2.
Remove the front bezel (see "Front Bezel").
3.
Figure 5-4 Removing the Battery