Operation; Starting Up - NEC POWERMATE ENTERPRISE NETPC Service Manual

OPERATION

The following sections provide basic procedures for starting up and shutting down the
computer.

Starting Up

Power on the system using the following steps.
Plug the monitor power cable into a grounded wall outlet.
1.
Plug the computer's power cable into the AC power-in connector on the back
2.
panel of the computer and into a grounded wall outlet.
If the computer does not turn on, press the power button on the front panel (see
the following figure). Use the lamps on the front panel to verify that the power,
hard disk drive, and LAN connections are working as follows:
T
Power-on (green)/Sleep mode (yellow)
This LED indicates the operating status of the machine (see Table 2-2).
Color State
Off Off
Green Continuous
Yellow Continuous
Green/ Blinking
Yellow
CAUTION: Ensure that the power service
connection is through a properly grounded
outlet.
NECCSD recommends that you plug the
computer into a surge suppresser for protection
against sudden transient increases or decreases in
electrical power that could damage the
computer's power supply and result in loss of
data.
Table 2-2 Power LED Functions
Function
System is powered
down.
System is powered on.
System is suspended.
System is powered on
with a message waiting.
Technical Information
Notes
If AC is connected, system
should respond to Wake-Up
events.
This is normal operation mode.
This is traditional sleep mode.
This feature requires a modem
and software support.
2-7