Replacement - NEC POWERMATE ENTERPRISE NETPC Service Manual

4. Separate the two halves of the chassis (see "Opening the System Chassis" in
Section 3).
Remove the system board and riser card (see "System Board and Riser Card").
5.
Using a medium straight-blade screwdriver, pry under the EMI shield and
6.
free the shield (see Figure 5-5, B).
Swing the EMI shield out and disengage it from the tabs at the top (see
7.
Figure 5-5, A).

Replacement

To replace the EMI shield, proceed as follows:
1. Complete steps 1 through 7 in the previous subsection.
Insert the EMI shield under the two tabs at the top-left side (see Figure 5-5, A).
2.
Swing the EMI shield in and engage the four tabs at the bottom (see
3.
Figure 5-5, B).
4. Reinstall the system board and riser card (see "System Board and Riser Card").
5. Reattach the top and bottom halves of the chassis (see "Closing the System
Chassis" in Section 3).
A.
B.
Figure 5-5 Removing the EMI Shield
Disassembly and Reassembly 5-9