Setup Utility - NEC POWERMATE ENTERPRISE NETPC Service Manual

2-10 Technical Information
4. Press the Windows
"Shut Down" gives you several choices in the pop-up submenu. Select "Shut
down the computer," then click the
computer.
Turn off power to the monitor.
5.
Power off the system by pressing the system unit power button.
6.
This completes the system setup procedures. For information about using the Setup Utility
to set system parameters, see the following subsection.

SETUP UTILITY

The Setup utility program is used to configure the main components of the computer.
System configuration information is stored in nonvolatile memory. A nonvolatile memory
device retains its data when system power is turned off. Nonvolatile memory in the system
is stored in a complementary metal-oxide semiconductor (CMOS) chip backed up by a
battery on the system board. The battery supplies continuous power to CMOS memory and
maintains configuration information when system power is off.
button, then point to and click "Shut Down." Selecting
Start
NOTE: A message appears informing you when
it is safe to turn off the system.
NOTE: The system ships from the factory with
the correct system parameters for the
configuration. Unless you add optional hardware,
you do not need to run Setup to operate the
system. However, you might wish to run the
Setup utility to set features that customize the
system, such as security features.
NOTE: NECCSD recommends that you print
out or write down the current Setup parameters
and store the information in a safe place. This
allows you to restore the system to the current
parameters if you ever need to have the battery
replaced.
button or press
Yes Enter
to shut down the