Monitor Selection On First Boot; Landesk Client Manager Setup - NEC POWERMATE PRO2180 - SERVICE MANUAL 1997 Service Manual

Section 2
Setup and Installation
This section provides information on installing the hardware drivers and other software in
the PowerMate Pro2200/2180 systems. In addition, valuable information about the
computer that was not included in the user's guide or service and reference manual is
included.

MONITOR SELECTION ON FIRST BOOT

If your monitor does not support the 75 Hz refresh, change the refresh rate during the initial
boot process. When the system starts, you will see the following prompt:
Please select the operating system to start:
Select "Windows NT Workstation Version 4.00 (VGA Mode)." This selection provides a
refresh rate of 60 Hz.

LANDESK CLIENT MANAGER SETUP

Use the following procedure to set up the LANDesk Client Manager software.
Press the Start button on the taskbar.
1.
2. Scroll up to "Programs" to open the Programs menu.
3. Move the cursor over the "Intel LANDesk" selection and click on "Client
Manager 3.0 Setup."
Follow the instructions in the Setup program.
4.
NOTE: Before connecting your monitor to the
system, check the monitor's documentation for
its supported refresh rates and resolutions. The
monitor must support 800x600 by 256 colors at
75 Hz. This is the default resolution.
NOTE: When you log into Windows NT for the
first time, be sure to log in as administrator and
set a password.