Table of Contents
Advertisement
| Configuring the Switch
C
4
HAPTER
IEEE 802.1Q VLANs
C
VLAN
ONFIGURING
A
P
TTRIBUTES FOR
ORT
M
EMBERS
printers. Note that if you implement VLANs which do not overlap, but
still need to communicate, you must connect them through a router.
W
I
EB
NTERFACE
To configure IEEE 802.1Q VLAN groups:
Click Configuration, VLANs, VLAN Membership.
1.
Change the ports assigned to the default VLAN (VLAN 1) if required.
2.
To configure a new VLAN, click Add New VLAN, enter the VLAN ID, and
3.
then mark the ports to be assigned to the new group.
Click Save.
4.
Figure 21: VLAN Membership Configuration
You can configure VLAN attributes for specific interfaces, including whether
or not the ports are VLAN aware, enabling ingress filtering, accepting
Queue-in-Queue frames with embedded tags, setting the accepted frame
types, and configuring the default VLAN identifier (PVID).
P
ARAMETERS
The following parameters are displayed on the VLAN Port Configuration
page:
Port - Port identifier.
◆
◆
VLAN Aware - Configures whether or not a port processes the
VLAN ID in ingress frames. (Default: Disabled)
If a port is not VLAN aware, all frames are assigned to the default VLAN
(as specified by the Port VLAN ID) and tags are not removed.
If a port is VLAN aware, each frame is assigned to the VLAN indicated in
the VLAN tag, and the tag is removed.
Ingress Filtering - Determines how to process frames tagged for
◆
VLANs for which the ingress port is not a member. (Default: Disabled)
Ingress filtering only affects tagged frames.
■
– 102 –
Advertisement
Table of Contents
Troubleshooting
