Configuring Snmpv3 Group Access Rights - SMC Networks 8028L2 - annexe 1 Management Manual

Use the SNMP Accesses Configuration menu to assign portions of the MIB
C
ONFIGURING
tree to which each SNMPv3 group is granted access. You can assign more
SNMP 3 G
V ROUP
than one view to a group to specify access to different portions of the MIB
A R
CCESS IGHTS
tree.
P
ARAMETERS
The following parameters are displayed on the SNMPv3 Access
Configuration page:
Group Name - The name of the SNMP group. (Range: 1-32 characters,
◆
ASCII characters 33-126 only)
Security Model - The user security model. (Options: any, v1, v2c, or
◆
the User-based Security Model – usm; Default: any)
Security Level - The security level assigned to the group:
◆
■
■
■
Read View Name - The configured view for read access. (Range: 1-32
◆
characters, ASCII characters 33-126 only)
Write View Name - The configured view for write access.
◆
(Range: 1-32 characters, ASCII characters 33-126 only)
NoAuth, NoPriv - There is no authentication or encryption used in
SNMP communications. (This is the default for SNMPv3.)
Auth, NoPriv - SNMP communications use authentication, but the
data is not encrypted.
Auth, Priv - SNMP communications use both authentication and
encryption.
– 139 –
| Configuring the Switch
C 4
HAPTER
Simple Network Management Protocol