Qos Shaper - SMC Networks 8028L2 - annexe 1 Management Manual

| QoS Commands
C 22
HAPTER

qos shaper

C U
OMMAND SAGE
Rate limiting controls the maximum rate for traffic transmitted or received
on an interface. Rate limiting can be configured on interfaces at the edge of
a network to form part of the customer service package by limiting traffic
into or out of the switch. Packets that exceed the acceptable amount of
traffic are dropped, while conforming traffic is forwarded without any
changes.
E
XAMPLE
QoS>rate limiter enable 600
QoS>
This command displays or sets egress rate limiting for specified ports.
S
YNTAX
qos shaper [port-list] [enable | disable] [bit-rate]
port-list - A specific port or range of ports. (Range: 1-28, or all)
enable - Enables egress rate limiting.
disable - Disables egress rate limiting.
bit-rate - Maximum egress rate in kilobits/second.
(Range: 500-1000000 kbps)
D S
EFAULT ETTING
Disabled
500 kbps when enabled
C U
OMMAND SAGE
Rate limiting controls the maximum rate for traffic transmitted or received
on an interface. Rate limiting can be configured on interfaces at the edge of
a network to form part of the customer service package by limiting traffic
into or out of the switch. Packets that exceed the acceptable amount of
traffic are dropped, while conforming traffic is forwarded without any
changes.
E
XAMPLE
QoS>shaper enable 600
QoS>
– 314 –