Config Load - SMC Networks 8028L2 - annexe 1 Management Manual

| Config Commands
C 25
HAPTER

config load

This command loads configuration settings from a TFTP server to the
switch.
S
YNTAX
config load tftp-server file-name [check]
tftp-server - TFTP server's IP address. Valid IP addresses consist of
four numbers, 0 to 255, separated by periods.
file-name - The name of a previously saved configuration file. The
destination file name should not contain slashes (\ or /), the leading
letter of the file name should not be a period (.) and the maximum
length is 31 characters for files on the switch. (Valid characters: A-
Z, a-z, 0-9, ".", "-", "_")
check - Just check the configuration file for errors, do not apply
D S
EFAULT ETTING
Check and apply the file.
C U
OMMAND SAGE
You can also restore the factory default settings using the
default command (page
E
XAMPLE
Config>load 192.168.2.19 4548v-config
Config>
– 330 –
201).
system restore