Ip Setup - SMC Networks 8028L2 - annexe 1 Management Manual

If the IP DHCP option is enabled, the switch will start broadcasting
◆
service requests as soon as it is powered on.
E
XAMPLE
IP>dhcp enable
IP>dhcp
DHCP Client
Active Configuration:
IP Address
IP Mask
IP Router
DNS Server
SNTP Server
IP>
This command displays or sets the switch's IPv4 address and gateway for

ip setup

the specified VLAN.
S
YNTAX
ip setup [ip-addr] [network-mask] [gateway] [vlan-id]
ip-addr - IPv4 address.
network-mask - Network mask for the associated IP subnet. This
mask identifies the host address bits used for routing to specific
subnets.
gateway - IP address of the default gateway.
vlan-id - VLAN to which the management address is assigned.
(Range: 1-4095)
D S
EFAULT ETTING
IP Address:
Network Mask: 255.255.255.0
Gateway:
VLAN:
C U
OMMAND SAGE
Only one VLAN interface can be assigned an IP address (the default
N :
OTE
is VLAN 1). This defines the management VLAN, the only VLAN through
which you can gain management access to the switch. If you assign an IP
address to any other VLAN, the new IP address overrides the original IP
address and this becomes the new management VLAN.
You must assign an IP address to this device to gain management
◆
access over the network or to connect the switch to existing IP subnets.
You can manually configure a specific IP address, or direct the device to
obtain an address from a DHCP server using the
(page 210). Valid IP addresses consist of four numbers, 0 to 255,
: Enabled
: 192.168.0.3
: 255.255.255.0
: 0.0.0.0
: 0.0.0.0
:
192.168.2.10
none
1
– 211 –
| IP Commands
C 10
HAPTER
ip dhcp command