Figure 13: Rstp Port Configuration - SMC Networks 8028L2 - annexe 1 Management Manual

| Configuring the Switch
C 4
HAPTER
Configuring the Spanning Tree Algorithm
during reconfiguration events, does not cause the spanning tree to
initiate reconfiguration when the interface changes state, and also
overcomes other STA-related timeout problems. However, remember
that this feature should only be enabled for ports connected to an end-
node device. (Default: Edge)
Auto Edge – Controls whether automatic edge detection is enabled on
◆
a bridge port. When enabled, the bridge can determine that a port is at
the edge of the network if no BPDU's received on the port.
(Default: Enabled)
Point2Point – The link type attached to an interface can be set to
◆
automatically detect the link type, or manually configured as point-to-
point or shared medium. Transition to the forwarding state is faster for
point-to-point links than for shared media. These options are described
below:
Auto – The switch automatically determines if the interface is
■
attached to a point-to-point link or to shared medium. (This is the
default setting.)
Forced True – A point-to-point connection to exactly one other
■
bridge.
Forced False – A shared connection to two or more bridges.
■
W I
EB NTERFACE
To configure interface settings for RSTP:
Click Configuration, Spanning Tree, Ports.
1.
Modify the required attributes.
2.
Click Save.
3.

Figure 13: RSTP Port Configuration

– 80 –