Table of Contents
Advertisement
C
U
OMMAND
The transmit delay is used to prevent a series of successive LLDP
transmissions during a short period of rapid changes in local LLDP MIB
objects, and to increase the probability that multiple, rather than single
changes, are reported in each transmission.
E
XAMPLE
LLDP>delay 10
LLDP>
This command displays or sets the delay before attempting to re-initialize
lldp reinit
information in the remote system's LLDP MIB after LLDP ports are disabled
or the link goes down.
S
YNTAX
lldp reinit [reinit]
reinit - The delay before attempting to re-initialize after LLDP ports
are disabled or the link goes down. (Range: 1-10 seconds)
D
S
EFAULT
ETTING
2 seconds
C
U
OMMAND
When LLDP is re-initialized on a port, all information in the remote system's
LLDP MIB associated with this port is deleted.
E
XAMPLE
LLDP>reinit 10
LLDP>
This command displays information about devices connected directly to the
lldp info
switch's ports which are advertising information through LLDP.
S
YNTAX
lldp info [port-list]
port-list - A specific port or a range of ports. (Range: 1-28, or all)
D
S
EFAULT
ETTING
All ports
C
U
OMMAND
For a description of the information displayed by this command, see
"Displaying LLDP Neighbor Information" on page
SAGE
SAGE
SAGE
– 287 –
| LLDP Commands
C
18
HAPTER
174.
Advertisement
Table of Contents
Troubleshooting
