Igmp Commands; Igmp Configuration; Table 29: Igmp Commands - SMC Networks 8028L2 - annexe 1 Management Manual

17

igmp configuration

IGMP C
OMMANDS
This switch uses IGMP (Internet Group Management Protocol) to query for
any attached hosts that want to receive a specific multicast service. It
identifies the ports containing hosts requesting a service and sends data
out to those ports only. It then propagates the service request up to any
neighboring multicast switch/router to ensure that it will continue to
receive the multicast service.
This section describes the commands used to configure IGMP snooping,
query, throttling, and filtering.

Table 29: IGMP Commands

Command Function
igmp configuration Displays IGMP snooping settings for the switch, all VLANs, and
specified ports
igmp mode Displays or sets the IGMP snooping mode for the switch
igmp state Displays or sets the IGMP snooping state for specified VLAN
igmp querier Displays or sets the IGMP querier mode for specified VLAN
igmp fastleave Displays or sets IGMP fast leave for specified ports
igmp leave proxy Displays or sets IGMP leave proxy for the switch
igmp throttling Displays or sets IGMP group throttling for specified ports
igmp filtering Displays or sets IGMP group filtering for specified ports
igmp router Displays or sets specified ports which are attached to a known
IGMP router
igmp flooding Displays or sets flooding of unregistered IGMP services
igmp groups Displays active IGMP groups
igmp status Displays IGMP querier status and protocol statistics
This command displays IGMP snooping settings for the switch, all VLANs,
and specified ports.
S
YNTAX
igmp configuration [port-list]
port-list - A specific port or a range of ports. (Range: 1-28, or all)
D S
EFAULT ETTING
All ports
– 273 –