Virtual Lans; Traffic Prioritization - SMC Networks 8028L2 - annexe 1 Management Manual

The switch supports up to 256 VLANs. A Virtual LAN is a collection of
V LAN
IRTUAL S
network nodes that share the same collision domain regardless of their
physical location or connection point in the network. The switch supports
tagged VLANs based on the IEEE 802.1Q standard. Members of VLAN
groups can be dynamically learned via GVRP, or ports can be manually
assigned to a specific set of VLANs. This allows the switch to restrict traffic
to the VLAN groups to which a user has been assigned. By segmenting
your network into VLANs, you can:
Eliminate broadcast storms which severely degrade performance in a
◆
flat network.
Simplify network management for node changes/moves by remotely
◆
configuring VLAN membership for any port, rather than having to
manually change the network connection.
Provide data security by restricting all traffic to the originating VLAN.
◆
Use private VLANs to restrict traffic to pass only between data ports
◆
and the uplink ports, thereby isolating adjacent ports within the same
VLAN, and allowing you to limit the total number of VLANs that need to
be configured.
◆ Use protocol VLANs to restrict traffic to specified interfaces based on
protocol type.
This switch prioritizes each packet based on the required level of service,
T
RAFFIC
using four priority queues with strict or Weighted Round Robin Queuing. It
P
RIORITIZATION
uses IEEE 802.1p and 802.1Q tags to prioritize incoming traffic based on
input from the end-station application. These functions can be used to
provide independent priorities for delay-sensitive data and best-effort data.
This switch also supports several common methods of prioritizing layer 3/4
traffic to meet application requirements. Traffic can be prioritized based on
the priority bits in the IP frame's Type of Service (ToS) octet or the number
of the TCP/UDP port. When these services are enabled, the priorities are
mapped to a Class of Service value by the switch, and the traffic then sent
to the corresponding output queue.
– 31 –
| Introduction
C 1
HAPTER
Description of Software Features