Config Commands; Config Save; Table 39: Configuration Commands - SMC Networks 8028L2 - annexe 1 Management Manual

25

config save

C C
ONFIG OMMANDS
This section describes commands used to saves or restore configuration
settings.

Table 39: Configuration Commands

Command Function
config save Saves configuration settings to a TFTP server
config load Loads configuration settings from a TFTP server
This command saves the switch's current configuration settings to a file on
a TFTP server.
S
YNTAX
config save tftp-server file-name
tftp-server - TFTP server's IP address. Valid IP addresses consist of
four numbers, 0 to 255, separated by periods.
file-name - The name of the file to store on the TFTP server.
C U
OMMAND SAGE
When you save the system code or configuration settings to a file on a
◆
TFTP server, that file can later be downloaded to the switch to restore
system operation. The success of the file transfer depends on the
accessibility of the TFTP server and the quality of the network
connection.
The configuration file is in XML format. The configuration parameters
◆
are represented as attribute values. When saving the configuration
from the switch, the entire configuration including syntax descriptions
is included in the file. The file may be modified using an editor and
loaded to a switch.
E
XAMPLE
Config>save 192.168.2.19 4548v-config
Saved 29683 bytes to server
Config>
– 329 –