HANGCHA CPCD15 Operation And Maintenance Manual page 86

Caution
Some models are not equipped with an " "OPS indicator light on the instrument panel.

For the forklift trucks with seats provided with a safety belt protection switch, after the

driver first sits back on the driver's seat properly and fastens his/her safety belt, normal
operation can be conducted.
 The neutral indicator light flashes: The shift switch is in the neutral position by default in the
program, and the driver is reminded about pulling to the neutral position.
Caution
 If the OPS system is activated by accident when driving uphill, it will disconnect the driving
power, making the forklift truck roll backwards. In order to avoid accidents, the driver must
sit on the driver's seat properly when driving uphill.
3. Working device protection
When the driver leaves his/her seat or his/her safety belt is loose (if the safety belt protection switch
is provided) for more than 3s when operating, the buzzer will sound an alarm, the OPS indicator light
will turn on, and the handling operation will be automatically stopped. If the driver sits on the driver's
seat properly again, the handling operation will continue.
Caution
For the forklift trucks with seats provided with a safety belt protection switch, after the

driver first sits back on the driver's seat properly and fastens his/her safety belt, normal
operation can be conducted.
 Tilt the lever and accessory lever to the initial positions before releasing protection.
OPS controller faults
In the event of the following conditions, the forklift truck should be stopped in a safe place and
Hangcha agency should be contacted for inspection.
a) When you are ready to start the forklift truck, and you pull the shift switch to forward gear 1
or backward gear 1, the neutral indicator light will flash.
b) When you pull up the hand brake, the buzzer will continue to sound an alarm.
c) When the shift switch is pulled to the neutral position, the neutral indicator light will
continue to flash.
d) When the driver leaves his/her seat or his/her safety belt is loose (if the safety belt
protection switch is provided) for more than 3s, the buzzer will not sound an alarm, and the OPS
indicator light will not turn on.
e) When the driver sits on the driver's seat properly again, the buzzer will continue to sound an
alarm and the OPS indicator light will not turn off.