HANGCHA CPCD15 Operation And Maintenance Manual page 68

4. Stacking
a ） Slow down when approaching the place to
store the cargo.
b）Park the truck in front of the place to store
the cargo.
c）Check the place to store the cargo.
d）Tilt the mast forward to the fork level and lift
the forks to a position slightly higher than the
unloading site.
e） Move forward, put the cargo on the unloading
site and stop.
f） Slowly lower the forks after confirming that
the cargo is above the unloading site and
confirm that the cargo is safe and in place.
g ） Conduct necessary lifting and tilting
operations, move the forklift truck back and take
the forks out from the cargo.
h）Lower forks to 15cm-20cm above the ground
after fork tips are clear from the cargo.
64
i）Tilt the mast backwards
Caution
Do not tilt the mast when the load is lifted

above 2m.
Do not get off the truck or leave the truck

when the load is at a high level.
5. Unstacking
a） Slow down when the forklift truck approaches
the place to pick up the cargo.
b ） Park when the forklift truck is 30cm away
from the cargo.
c）Check the cargo condition.
d）Tilt the mast forward to the fork level and lift
the forks to the position of pallet or crosstie.
e ） Confirm whether the forks are aligned with
the pallets, move forward slowly, try to insert
forks into the pallets and stop.
Caution
If it is difficult to insert forks fully into the

pallets, the truck can move forward to
insert the forks 3/4 of the way into the
pallets. Lift the forks 5cm-10cm, move the
truck backwards 10cm-20cm, lower the
pallets or crossties, and move the truck
forward to fully insert the forks into the
pallets or crossties.
f ） Lift the forks 5cm-10cm above the stacking
place.
g） Look around the truck, confirm whether there
are any obstacles, and move backwards slowly.
h ） Lower the forks to 15cm-20cm above the
ground, tilt the mast backwards, and transport
the cargo to the destination.