Source Technologies ST9917 User Manual page 66

Use printer menus
Menu item
Tray Configuration
Multiple Universal Sizes
Off*
On
Reports
Menu Settings Page
Event Log
Event Log Summary
Supply Usage And Counters
Clear Supply Usage History
Supply Usage And Counters
Reset Maintenance Counter
Printer Emulations
PPDS Emulation
Off*
On
Printer Emulations
PS Emulation
Off
On*
Printer Emulations
Enable Formsmerge
Off*
On
Printer Emulations
Enable Prescribe
Off*
On
Printer Emulations
Emulator Security
Page Timeout (60 minutes*)
Reset Emulator After Job (Off*)
Disable Printer Message Access (On*)
Print Configuration
Font Sharpening
0–150 (24*)
Print Configuration
Print Density
Disabled
1–5 (3*)
Note: An asterisk (*) next to a value indicates the factory default setting.
Description
Set the tray to support multiple universal sizes.
Print reports about printer menu settings, status, and event
logs.
Reset the supply usage history to the factory default level.
Reset the counter after installing a new maintenance kit.
Set the printer to recognize and use the PPDS data stream.
Set the printer to recognize and use the PS data stream.
Activate Forms Merge to store the forms into the hard disk or
intelligent storage drive (ISD).
Note: A hard disk or an ISD must be installed.
Activate Prescribe.
Note: The Prescribe license must be installed.
Configure the security settings of the printer during emulation
mode.
Set a text point-size value below which the high‑frequency
screens are used when printing font data.
For example, if the value is 24, then all fonts sized 24 points or
less use the high‑frequency screens.
Adjust the toner density when printing documents.
65