Source Technologies ST9917 User Manual page 86

Use printer menus
Menu item
Enable mDNS
Off
On*
WINS Server Address
Enable BOOTP
Off*
On
Restricted Server List
Restricted Server List Options
Block All Ports*
Block Printing Only
Block Printing and HTTP Only
MTU
256–1500 Ethernet (1500*)
Raw Print Port
1–65535 (9100*)
Outbound Traffic Maximum
Speed
Off*
On
TLS Support
Enable TLSv1.0 (Off)
Enable TLSv1.1 (Off*)
Enable TLSv1.2 (On*)
SSL Cipher List
TLSv1.3 SSL Cipher List
Note: An asterisk (*) next to a value indicates the factory default setting.
SNMP
Note: This menu appears only in network printers or printers that are attached to print servers.
Description
Update the multicast DNS settings.
Specify a server address for Windows Internet Name Service (WINS).
Allow the BOOTP to assign a printer IP address.
Specify the IP addresses that are allowed to communicate with the printer over
TCP/IP.
Notes:
•
Use a comma to separate each IP address.
•
You can add up to 50 IP addresses.
•
This menu item is available only in some printer models.
Specify the access option for IP addresses that are not in the list.
Note: This menu item is available only in some printer models.
Specify a maximum transmission unit (MTU) parameter for the TCP connections.
Specify a raw port number for printers connected on a network.
Set the maximum transfer rate of the printer.
Note: When enabled, the option for this setting is 100–1000000
Kilobits/second.
Enable the Transport Layer Security protocol.
Specify the cipher algorithms to use for the SSL or the TLS connections.
Specify the specific cipher string to use for TLS v1.3.
85