Source Technologies ST9917 User Manual page 14

Learn about the printer
Selecting preprinted forms and letterhead
•
Use grain long paper.
•
Use only forms and letterhead printed using an offset lithographic or engraved printing process.
•
Avoid paper with rough or heavily textured surfaces.
•
Use inks that are not affected by the resin in toner. Inks that are oxidation‑set or oil‑based generally meet
these requirements; latex inks might not.
•
Print samples on preprinted forms and letterheads considered for use before buying large quantities. This
action determines whether the ink in the preprinted form or letterhead affects print quality.
•
When in doubt, contact your paper supplier.
•
When printing on letterhead, load the paper in the proper orientation for your printer.
Supported paper sizes
Paper size
A4
210 x 297 mm
(8.27 x 11.7 in.)
A5 Portrait (SEF)
148 x 210 mm
(5.83 x 8.27 in.)
1
A5 Landscape (LEF)
210 x 148 mm
(8.27 x 5.83 in.)
2
A6
105 x 148 mm
(4.13 x 5.83 in.)
JIS B5
182 x 257 mm
(7.17 x 10.1 in.)
Oficio (Mexico)
216 x 340 mm
(8.5 x 13.4 in.)
Hagaki
100 x 148 mm
(3.93 x 5.83 in.)
1
The default support is short‑edge feed.
2
Supported only in the MS639 printer model.
3
When Universal is selected, the page is formatted for 215.90 x 355.60 mm (8.5 x 14 in.) unless specified by the
application.
4
Paper must at least be 210 mm (8.27 in.) wide and 279.4 mm (11 in.) long for two‑sided printing.
Standard 250‑ or Optional 250‑ or
550‑sheet tray 550‑sheet tray
X
Multipurpose feeder
2
X
13
Two‑sided
printing
X
X
X
X
X