Dscp Setting - ZyXEL Communications MS-7206 - EDITION 1 Manual

Table 91 2-rate 3 Color Marker (continued)
LABEL DESCRIPTION
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use
this row first to set the common settings and then make adjustments on a port-
by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make
Active Select this to activate TRTCM on the port.
Commit Specify the Commit Information Rate (CIR) for this port.
Rate
Peak Specify the Peak Information Rate (PIR) for this port.
Rate
DSCP Use this section to specify the DSCP values that you want to assign to packets
based on the color they are marked via TRTCM.
green Specify the DSCP value to use for packets with low packet loss priority.
yellow Specify the DSCP value to use for packets with medium packet loss priority.
red Specify the DSCP value to use for packets with high packet loss priority.
Apply Click Apply to save your changes to the switch's run-time memory. The switch
loses these changes if it is turned off or loses power, so use the Save link on
the top navigation panel to save your changes to the non-volatile memory when
you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.

36.5 DSCP Setting

Use this screen to configure the DSCP to IEEE 802.1p mapping to allow the switch
to prioritize all traffic based on the incoming DSCP value according to the DiffServ
to IEEE 802.1p mapping table. The following table shows the default DSCP-to-
IEEE-802.1p mapping.
Table 92 Default DSCP-IEEE-802.1p Mapping
DSCP Value
IEEE802.1p
MS-7206 User's Guide
them.
0 – 7 8 – 15 16 – 23 24 – 31 32 – 39 40 – 47 48 – 55 56 – 63
0 1 2
Chapter 36 Differentiated Services
3 4 5 6 7
269