Ip Setup - ZyXEL Communications MS-7206 - EDITION 1 Manual

Table 12 IP Setup (continued)
LABEL
Default
Management
Management
IP Address
IP
Address
IP Subnet
Mask
Default
Gateway
Apply
Cancel
IP Interface
IP
Address
IP Subnet
Mask
VID
Add
Cancel
Index
IP Address
Subnet Mask
VID
Delete
Cancel
MS-7206 User's Guide
DESCRIPTION
Specify which traffic flow (In-Band or Out-of-band) the switch is to send
packets originating from itself (such as SNMP traps) or packets with
unknown source.
Select Out-of-band to have the switch send the packets to the
management port labelled MGMT. This means that device(s) connected to
the other port(s) do not receive these packets.
Select In-Band to have the switch send the packets to all ports except the
management port (labelled MGMT) to which connected device(s) do not
receive these packets.
Use these fields to set the settings for the out-of-band management port.
Enter the out-of-band management IP address of your switch in dotted
decimal notation. For example, 192.168.0.1.
Enter the IP subnet mask of your switch in dotted decimal notation for
example 255.255.255.0.
Enter the IP address of the default outgoing gateway in dotted decimal
notation, for example 192.168.0.254
Click Apply to save your changes to the switch's run-time memory. The
switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to reset the fields to your previous configuration.
Use these fields to create or edit IP routing domains on the switch.
Enter the IP address of your switch in dotted decimal notation for example
192.168.1.1. This is the IP address of the switch in an IP routing domain.
Enter the IP subnet mask of an IP routing domain in dotted decimal
notation. For example, 255.255.255.0.
Enter the VLAN identification number to which an IP routing domain
belongs.
Click Add to save your changes to the switch's run-time memory. The
switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to reset the fields to your previous configuration.
This field displays the index number of an entry.
This field displays IP address of the switch in the IP domain.
This field displays the subnet mask of the switch in the IP domain.
This field displays the VLAN identification number of the IP domain on the
switch.
Click Delete to remove the selected entry from the summary table.
Note: Deleting all IP subnets locks you out from the switch.
Click Cancel to clear the Delete check boxes.
Chapter 10 IP Setup
75