Configure Dscp Setting; Figure 84 Diffserv; Table 60 Static Routing - ZyXEL Communications ZyXEL Dimension ES-3148 User Manual

ES-3148 User's Guide
The following table describes the related labels you use to create a static route.

Table 60 Static Routing

LABEL
DSCP Setting
Active
Port
*
Active
Apply
Cancel

25.3 Configure DSCP Setting

Use this screen to convert DSCP priority to IEEE 802.1p priority. Click IP Application,
DiffServ, DSCP in the navigation panel to display the screen as shown.

Figure 84 DiffServ

184
DESCRIPTION
Click DSCP Map to open the screen where you can set up the mapping between
source DSCP priority and IEEE 802.1p priority.
This field allows you to activate/deactivate DiffServ on the switch.
This read-only index number indicates which port you are activating.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this
row first to set the common settings and then make adjustments on a port-by-port
basis.
Note: Changes in this row are copied to all the ports as soon as you
make them.
This allows you to activate DiffServ on a per port basis.
Click Apply to save your changes to the switch's run-time memory. The switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to reset the fields.
Chapter 25 DiffServ Code Point