Port Status; Chapter 6 System Status And Port Statistics - ZyXEL Communications MS-7206 - EDITION 1 Manual

Chapter 6 System Status and Port Statistics

Table 5 Status (continued)
LABEL
Up Time
F/W Version

6.1.1 Port Status

Use this screen to look at the status of each port in the selected slot. You can also
clear the port counters for each port in the slot. To open this screen, click Status
in any web configurator screen, and then click the number of the slot.
Figure 16 Port Status
The following table describes the labels in this screen.
Table 6 Port Status
LABEL
Port
Name
Link
State
PD
56
DESCRIPTION
This field shows the total amount of time in hours, minutes and seconds
the card has been up in the slot.
This field displays the version number of the card's current firmware
including the date created.
DESCRIPTION
This field displays the slot number and the port number. Click a port
number to look at detailed statistics for a specific port. See
on page 57.
This is the name assigned to this port. You can configure this in the Port
Setup screen. See Chapter 12 on page
This field displays the speed (either 10M for 10 Mbps, 100M for 100 Mbps,
1000M for 1000 Mbps, or 10G for 10-Gigabit) and the duplex (F for full
duplex or H for half). It shows Down if there is no connection. You can
configure some of these settings in the Port Setup screen. See
on page 79.
If STP (Spanning Tree Protocol) is enabled, this field displays the STP state
of the port. If STP is disabled, this field displays FORWARDING if the link
is up, otherwise, it displays STOP. See
information about STP.
This field displays the current amount of power consumed by devices
(powered devices, or PD) that use Power over Ethernet (PoE) to get power
from the switch on this port.
Section 6.1.2
79.
Chapter 16 on page 105
MS-7206 User's Guide
Chapter 12
for more