Ospf Interface - ZyXEL Communications MS-7206 - EDITION 1 Manual

Chapter 33 OSPF
Table 85 OSPF Configuration (continued)
LABEL
Default Route
Cost
Add
Cancel
Clear
Index
Name
Area ID
Authentication
Stub Network
Delete
Cancel

33.4 OSPF Interface

Use this screen to configure an OSPF interface. See
more information on OSPF.
Note: You have to create an IP routing domain in the IP Setup screen first. Once you
create an IP routing domain, an OSPF interface entry is automatically created.
See
252
DESCRIPTION
Specify a cost (between 0 and 16777214) used to add a default route
into a stub area for routes which are external to an OSPF domain. If you
do not set a route cost, no default route is added.
Click Add to save your changes to the switch's run-time memory. The
switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to start configuring the above fields again.
Click Clear to set the above fields back to the factory defaults.
Use this section to look at a summary of all the areas.
This field displays the index number of an area.
This field displays the descriptive name of an area.
This field displays the area ID (that uses the format of an IP address in
dotted decimal notation) that uniquely identifies an area.
An area ID of 0.0.0.0 indicates the backbone.
This field displays the authentication method used (None, Simple or
MD5).
This field displays whether an area is a stub network (Yes) or not (No).
Click Delete to remove the selected entry from the summary table.
Click Cancel to clear the Delete check boxes.
Section 10.2 on page 74
Section 33.1 on page 245
for more information about IP routing domains.
for
MS-7206 User's Guide