Configuring Snmp Trap Group - ZyXEL Communications MS-7206 - EDITION 1 Manual
Modular ethernet switch system
Hide thumbs
Also See for MS-7206 - EDITION 1:
- User manual (366 pages) ,
- Specifications (4 pages) ,
- Sales manual (7 pages)
Table of Contents
Advertisement
Chapter 40 Access Control
Table 110 SNMP (continued)
LABEL
Privacy
Apply
Cancel
40.2.5 Configuring SNMP Trap Group
Click Management > Access Control > SNMP > Trap Group to view the screen
as shown. Use the Trap Group screen to specify the types of SNMP traps that
should be sent to each SNMP manager.
Figure 156 SNMP Trap Group
310
DESCRIPTION
Specify the encryption method for SNMP communication from this
user. You can choose one of the following:
•
DES - Data Encryption Standard is a widely used (but breakable)
method of data encryption. It applies a 56-bit key to each 64-bit
block of data.
•
AES - Advanced Encryption Standard is another method for data
encryption that also uses a secret key. AES applies a 128-bit key
to 128-bit blocks of data.
Click Apply to save your changes to the switch's run-time memory.
The switch loses these changes if it is turned off or loses power, so
use the Save link on the top navigation panel to save your changes
to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
MS-7206 User's Guide
Advertisement
Table of Contents
Troubleshooting
