Setting Port Vid - ZyXEL Communications MS-7206 - EDITION 1 Manual

Chapter 5 Initial Setup Example
In the Static VLAN screen, select
2
ACTIVE, enter a descriptive name
in the Name field and enter 2 in
the VLAN Group ID field for the
VLAN2 network.
Select Slot 3 in the drop-down box
3
above the port list.
Note: The VLAN Group ID field in this screen and the VID field in the IP Setup
screen
Since the VLAN2 network is connected to port 1 in slot 3, select Fixed to
4
configure port 1 to be a permanent member of the VLAN only.
To ensure that VLAN-unaware devices (such as computers and hubs) can receive
5
frames properly, clear the TX Tagging check box to set the switch to remove
VLAN tags before sending.
Click Add to save the settings to the run-time memory. Settings in the run-time
6
memory are lost when the MM-7201's power is turned off.

5.4 Setting Port VID

Use PVID to add a tag to incoming untagged frames received on that port so that
the frames are forwarded to the VLAN group that the tag defines. In the example
network, configure 2 as the port VID on port 1 in slot 3 so that any untagged
frames received on that port get sent to VLAN 2.
Figure 14 Initial Setup Network Example: Port VID
52
(Section 5.1 on page 49) refer to the same VLAN ID.
Slot 3, Port 1, PVID 2
MS-7206 User's Guide