The following table describes the labels in this screen.
Table 90 Diffserv
LABEL
Active
Slot
Port
*
Active
Apply
Cancel
36.4 2-Rate 3 Color Marker
Use this screen to configure TRTCM settings. Click the 2-rate 3 Color Marker link
in the DiffServ screen to display the screen as shown next.
MS-7206 User's Guide
DESCRIPTION
Select this option to enable DiffServ on the switch.
Select the slot at whose settings you want to look.
This field displays the slot number and port number.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports.
Use this row first to set the common settings and then make adjustments
on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you
make them.
Select this option to enable DiffServ on the port.
Click Apply to save your changes to the switch's run-time memory. The
switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to start configuring this screen again.
Chapter 36 Differentiated Services
267