Group Configuration - ZyXEL Communications MS-7206 - EDITION 1 Manual
Modular ethernet switch system
Hide thumbs
Also See for MS-7206 - EDITION 1:
- User manual (366 pages) ,
- Specifications (4 pages) ,
- Sales manual (7 pages)
Table of Contents
Advertisement
Chapter 27 Multicast
Table 58 MVR (continued)
LABEL
Slot
Port
*
Source Port
Receiver Port
None
Tagging
Add
Cancel
VLAN
Active
Name
Mode
Source Port
Receiver Port
802.1p
Delete
Cancel
27.8 Group Configuration
Use this screen to configure MVR IP multicast group addresses. All source ports
and receiver ports belonging to a multicast group can receive multicast data sent
to MVR IP multicast groups. See
information about MVR. To open this screen, click Advanced Application >
Multicast > Multicast Setting > MVR > Group Configuration.
190
DESCRIPTION
Select the slot at whose settings you want to look.
This field displays the slot number and port number.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all
ports. Use this row first to set the common settings and then make
adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you
make them.
Select this option to set this port as the MVR source port that sends and
receives multicast traffic. All source ports must belong to a single
multicast VLAN.
Select this option to set this port as a receiver port that only receives
multicast traffic.
Select this option to set the port not to participate in MVR. No MVR
multicast traffic is sent or received on this port.
Select this if you want the port to tag the VLAN ID in all outgoing frames
transmitted.
Click Add to save your changes to the switch's run-time memory. The
switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to reset the fields.
This field displays the multicast VLAN ID.
This field displays whether the multicast group is enabled or not.
This field displays the descriptive name for this setting.
This field displays the MVR mode.
This field displays the source port number(s).
This field displays the receiver port number(s).
This field displays the priority level.
To delete a multicast VLAN(s), select the rule(s) that you want to
remove in the Delete column, then click the Delete button.
Click Cancel to clear the Delete check boxes.
Section 27.6 on page 186
for background
MS-7206 User's Guide
Advertisement
Table of Contents
Troubleshooting
