Logins - ZyXEL Communications MS-7206 - EDITION 1 Manual

The following table describes the labels in this screen.
Table 111 SNMP Trap Group
LABEL
Trap
Destination IP
Type
Options
Apply
Cancel

40.3 Logins

Up to five people (one administrator and four non-administrators) may access the
switch via the web configurator at any one time.
• An administrator is someone who can both view and configure switch changes.
The username for the Administrator is always admin. The default administrator
password is 1234.
Note: It is highly recommended that you change the default administrator password.
• A non-administrator (username is something other than admin) is someone
who can view but not configure switch settings.
MS-7206 User's Guide
DESCRIPTION
Select one of your configured trap destination IP addresses. These are
the IP addresses of the SNMP managers. You must first configure a trap
destination IP address in the SNMP Setting screen.
Use the rest of the screen to select which traps the switch sends to that
SNMP manager.
Select the categories of SNMP traps that the switch is to send to the
SNMP manager.
Select the individual SNMP traps that the switch is to send to the SNMP
station. See Section 40.2.3 on page 303
The traps are grouped by category. Selecting a category automatically
selects all of the category's traps. Clear the check boxes for individual
traps that you do not want the switch to send to the SNMP station.
Clearing a category's check box automatically clears all of the category's
trap check boxes (the switch only sends traps from selected categories).
Click Apply to save your changes to the switch's run-time memory. The
switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Chapter 40 Access Control
for individual trap descriptions.
311