Enabling Rip; Figure 14 Initial Setup Network Example: Port Vid - ZyXEL Communications MS-7206 User Manual

Chapter 5 Initial Setup Example

Figure 14 Initial Setup Network Example: Port VID

1 Click Advanced Application >
VLAN > VLAN Port Setting.
2 Select Slot 3 in the drop-down
box above the port list.
3 Enter 2 in the PVID field for
port 1.
4 Click Apply to save your
changes back to the run-time
memory. Settings in the run-
time memory are lost when the
MM-7201's power is turned off.

5.5 Enabling RIP

To exchange routing information with other routing devices across different routing domains,
enable RIP (Routing Information Protocol) in the RIP screen.
1 Click IP Application and RIP in the navigation panel.
2 Select Both in the Direction
field to set the switch to
broadcast and receive
routing information.
3 In the Version field, select
RIP-1 for the RIP packet
format that is universally
supported.
4 Click Apply to save your
changes back to the run-time
memory. Settings in the run-time memory are lost when the MM-7201's power is turned
off.
58
Slot 3, Port 1, PVID 2
MS-7206 User's Guide