ZyXEL Communications MS-7206 User Manual page 322

Chapter 52 Multicast VLAN Registration Commands
mode
<dynamic|compati
ble>
group name
<name-str>
start-address
<ip>
end-address <ip>
8021p-priority
<0-7>
• Enter MVR mode. Create a multicast VLAN with the name multiVlan and the VLAN
ID of 3.
• Specify source ports 2, 3, 5 in slot 4 and receiver ports 6-8 in slot 4.
• Specify dynamic mode for the multicast group.
• Configure MVR multicast group addresses by the name of ipgroup.
• Exit MVR mode.
See the following example.
sysname(config)# mvr 3 name multivlan
sysname(config-mvr)# source-port 4/2,4/3,4/5 receiver-port 4/6-4/8
sysname(config-mvr)# mode dynamic
sysname(config-mvr)# group ipgroup start-address 224.0.0.1 end-address
--> 224.0.0.255
sysname(config-mvr)# exit
322
= Specifies dynamic (sends IGMP reports to all source ports in the
multicast VLAN) or compatible (does not send IGMP reports).
= A name to identify the MVR IP multicast group.
= Specifies the starting IP multicast address of the multicast group in
dotted decimal notation.
= Specifies the ending IP multicast address of the multicast group in
dotted decimal notation. Enter the same IP address as the start-
address if you want to configure only one IP address for the
multicast group.
= Specifies the IEEE 802.1p priority level (0-7) with which the
switch replaces the priority in outgoing IGMP control packets
(belonging to this multicast VLAN).
MS-7206 User's Guide