Figure 46 802.1X; Table 39 802.1X - ZyXEL Communications MS-7206 User Manual

Chapter 21 Port Authentication

Figure 46 802.1x

The following table describes the labels in this screen.

Table 39 802.1x

LABEL
Active
Slot
Port
*
Active
Reauthenticatio
n
Reauthenticatio
n Timer
Apply
Cancel
118
DESCRIPTION
Select this check box to permit 802.1x authentication on the switch.
Note: You must first enable 802.1x authentication on the switch
before configuring it on each port.
Select the slot at whose settings you want to look.
This field displays the slot number and port number.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this
row first to set the common settings and then make adjustments on a port-by-port
basis.
Note: Changes in this row are copied to all the ports as soon as you
make them.
Select this to permit 802.1x authentication on this port. You must first allow 802.1x
authentication on the switch before configuring it on each port.
Specify if a subscriber has to periodically re-enter his or her username and
password to stay connected to the port.
Specify how often a client has to re-enter his or her username and password to stay
connected to the port.
Click Apply to save your changes to the switch's run-time memory. The switch
loses these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Click Cancel to reset the fields.
MS-7206 User's Guide