Table 96 Configure Clone - ZyXEL Communications MS-7206 User Manual

Chapter 45 Configure Clone
The following table describes the labels in this screen.

Table 96 Configure Clone

LABEL
Source/
Destination
Port
Basic Setting
Advanced
Application
Apply
Cancel
240
DESCRIPTION
You can copy attributes from one port to one or more ports (first radio button) or from
one card to one or more cards (second radio button). Select the appropriate radio
button.
Under Source, specify the port or card whose attributes you want to copy.
Under Destination, specify the port(s) or card(s) to which you want to copy these
attributes. You can enter individual ports separated by a comma or a range of ports by
using a dash. Examples:
• 2, 4, 6 indicates that ports 2, 4 and 6 are the destination ports.
• 2-6 indicates that ports 2 through 6 are the destination ports.
Select which port settings (you configured in the Basic Setting menus) should be
copied to the destination port(s).
Select which port settings (you configured in the Advanced Application menus)
should be copied to the destination ports.
Click Apply to save your changes to the switch's run-time memory. The switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to reset the fields.
MS-7206 User's Guide