ZyXEL Communications MS-7206 User Manual page 130

Chapter 24 Policy Rule
Table 44 Policy (continued)
LABEL
Classifier(s)
Parameters
General
VLAN ID
Egress Port Select the slot and type the number of the port to which to forward packets for
Mirror Port
Priority
DSCP
TOS
Metering
Bandwidth
Out-of-
Profile
DSCP
Action
Forwarding
Priority
Diffserv
Outgoing
Metering
130
DESCRIPTION
This field displays the active classifier(s) you configure in the Classifier screen.
Select the classifier(s) to which this policy rule applies. To select more than one
classifier, press [SHIFT] or [CTRL] and select the choices at the same time.
Set the fields below for this policy. You only have to set the field(s) that is related to
the action(s) you configure in the Action field.
Specify a VLAN ID number.
classified traffic flow.
Select the slot and type the number of another port to which to forward packets for
classified traffic flow. This port can be used for mirroring. See
109.
Specify a priority level.
Specify a DSCP (DiffServ Code Point) number between 0 and 63.
Specify the type of service (TOS) priority level.
You can configure the desired bandwidth available to a traffic flow. Traffic that
exceeds the maximum bandwidth allocated (in cases where the network is
congested) is called out-of-profile traffic.
Specify the bandwidth in kilobit per second (Kbps). Enter a number between 1 and
1000000.
Specify a new DSCP number (between 0 and 63) if you want to replace or remark the
DSCP number for out-of-profile traffic.
Specify the action(s) the switch takes on the associated classified traffic flow.
Select No change to forward the packets.
Select Discard the packet to drop the packets.
Select Do not drop the matching frame previously marked for dropping to retain
the frames that were marked to be dropped before.
Select No change to keep the priority setting of the frames.
Select Set the packet's 802.1 priority to replace the packet's 802.1 priority field with
the value you set in the Priority field.
Select Send the packet to priority queue to put the packets in the designated
queue.
Select Replace the 802.1 priority field with the IP TOS value to replace the
packet's 802.1 priority field with the value you set in the TOS field.
Select No change to keep the TOS and/or DSCP fields in the packets.
Select Set the packet's TOS field to set the TOS field with the value you configure in
the TOS field.
Select Replace the IP TOS with the 802.1 priority value to replace the TOS field
with the value you configure in the Priority field.
Select Set the Diffserv Codepoint field in the frame to set the DSCP field with the
value you configure in the DSCP field.
Select Send the packet to the mirror port to send the packet to the mirror port.
Select Send the packet to the egress port to send the packet to the egress port.
Select Set the packet's VLAN ID to set the VLAN ID of the packet with the value you
configure in the VLAN ID field.
Select Enable to activate bandwidth limitation on the traffic flow(s) then set the
actions to be taken on out-of-profile packets.
Chapter 19 on page
MS-7206 User's Guide