Ieee 802.1Q Tagged Vlan Commands; Configuring Tagged Vlan - ZyXEL Communications MS-7206 User Manual

C
H A P T E R
IEEE 802.1Q Tagged VLAN
This chapter describes the IEEE 802.1Q Tagged VLAN and associated commands.

51.1 Configuring Tagged VLAN

The following procedure shows you how to configure tagged VLAN.
1 Use the IEEE 802.1Q tagged VLAN commands to configure tagged VLAN for the
switch.
• Use the
vlan <vlan-id>
switch automatically enters the
deactivate the VLAN(s).
• Use the
interface port-channel <port-list> command
interface mode to set the VLAN settings on a port, then use the pvid <vlan-id>
command to set the VLAN ID you created for the port-list to that specific port in the PVID
table.
• Use the
exit
sysname (config)# vlan 2000
sysname (config-vlan)# name up1
sysname (config-vlan)# fixed 4/5-4/8
sysname (config-vlan)# no untagged 4/5-4/8
sysname (config-vlan)# exit
sysname (config)# interface port-channel 4/5-4/8
sysname (config-interface)# pvid 2000
sysname (config-interface)# exit
2 Configure your management VLAN.
• Use the
vlan <vlan-id>
managing the switch, and the switch will activate the new management VLAN.
• Use the
inactive
sysname (config)# vlan 3
sysname (config-vlan)# inactive
MS-7206 User's Guide
command to configure or create a VLAN on the switch. The
config-vlan
command when you are finished configuring the VLAN.
command to create a VLAN (VID 3 in this example) for
command to disable the new management VLAN.
51
Commands
mode.Use the command to
inactive
to enter the config-
313