Vlan Port Setting; Figure 29 Vlan Port Setting - ZyXEL Communications MS-7206 User Manual

Table 18 Static VLAN (continued)
LABEL
Control
Tagging
Add
Cancel
Clear
VID
Active
Name
Delete
Cancel

13.6.3 VLAN Port Setting

Use this screen to configure the static VLAN (IEEE 802.1Q) settings on a port. See
13.2 on page 83
Advanced Application > VLAN > VLAN Port Setting.

Figure 29 VLAN Port Setting

MS-7206 User's Guide
DESCRIPTION
Select Normal for the port to dynamically join this VLAN group using GVRP. This is
the default selection.
Select Fixed for the port to be a permanent member of this VLAN group.
Select Forbidden if you want to prohibit the port from joining this VLAN group.
Select TX Tagging if you want the port to tag all outgoing frames transmitted with
this VLAN Group ID.
Click Add to save your changes to the switch's run-time memory. The switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Click Cancel to reset the fields.
Click Clear to start configuring the screen again.
This field displays the ID number of the VLAN group. Click the number to edit the
VLAN settings.
This field indicates whether the VLAN settings are enabled (Yes) or disabled (No).
This field displays the descriptive name for this VLAN group.
Click Delete to remove the selected entry from the summary table.
Click Cancel to clear the Delete check boxes.
for background information about VLAN. To open this screen, click
Chapter 13 VLAN
Section
89