Setting Port Vid; Figure 13 Initial Setup Network Example: Vlan - ZyXEL Communications MS-7206 User Manual

Figure 13 Initial Setup Network Example: VLAN

1 Click Advanced Application > VLAN > Static VLAN.
2 In the Static VLAN screen, select
ACTIVE, enter a descriptive
name in the Name field and enter
2 in the VLAN Group ID field
for the VLAN2 network.
3 Select Slot 3 in the drop-down
box above the port list.
The VLAN Group ID field in this screen and the VID field in the IP Setup
screen (Section 5.1 on page
4 Since the VLAN2 network is connected to port 1 in slot 3, select Fixed to configure port
1 to be a permanent member of the VLAN only.
5 To ensure that VLAN-unaware devices (such as computers and hubs) can receive frames
properly, clear the TX Tagging check box to set the switch to remove VLAN tags before
sending.
6 Click Add to save the settings to the run-time memory. Settings in the run-time memory
are lost when the MM-7201's power is turned off.

5.4 Setting Port VID

Use PVID to add a tag to incoming untagged frames received on that port so that the frames
are forwarded to the VLAN group that the tag defines. In the example network, configure 2 as
the port VID on port 1 in slot 3 so that any untagged frames received on that port get sent to
VLAN 2.
MS-7206 User's Guide
Slot 3, Port 1
55) refer to the same VLAN ID.
Chapter 5 Initial Setup Example
57