Table 7 Port Details - ZyXEL Communications MS-7206 User Manual

Chapter 6 System Status and Port Statistics
The following table describes the labels in this screen.

Table 7 Port Details

LABEL
Port Info
Port NO
Name
Link
Status
PD
PowerConsu
mption
PD
MaxCurrent
PD
MaxPower
LACP
TxPkts
RxPkts
Errors
Tx KBs/s
Rx KBs/s
Up Time
TX Packet
TX Packets
Multicast
Broadcast
Pause
RX Packet
RX Packets
Multicast
Broadcast
Pause
Control
TX Collision
Single
62
DESCRIPTION
This field displays the slot number and the port number.
This is the name assigned to this port. You can configure this in the Port Setup
screen. See Chapter 12 on page
This field displays the speed (either 10M for 10 Mbps, 100M for 100 Mbps or 1000M
for 1000 Mbps) and the duplex (F for full duplex or H for half). It shows Down if there is
no connection. You can configure some of these settings in the Port Setup screen.
See Chapter 12 on page 79.
If STP (Spanning Tree Protocol) is enabled, this field displays the STP state of the
port. If STP is disabled, this field displays FORWARDING if the link is up, otherwise, it
displays STOP. See Chapter 16 on page 95
This field displays the current amount of power consumed by devices (powered
devices, or PD) that use Power over Ethernet (PoE) to get power from the switch on
this port.
This field displays the maximum amount of current drawn by devices (powered
devices, or PD) that use Power over Ethernet (PoE) to get power from the switch on
this port.
This field displays the maximum amount of power consumed by devices (powered
devices, or PD) that use Power over Ethernet (PoE) to get power from the switch on
this port.
This fields displays whether LACP (Link Aggregation Control Protocol) is Enabled or
Disabled on the port. See Chapter 20 on page 111
This field shows the number of frames transmitted on this port.
This field shows the number of frames received on this port.
This field shows the number of errors received on this port.
This field shows the number of kilobytes per second transmitted on this port.
This field shows the number of kilobytes per second received on this port.
This field shows the total amount of time in hours, minutes and seconds the port has
been up.
This field shows the number of frames transmitted on this port.
This field shows the number of multicast frames transmitted on this port.
This field shows the number of broadcast frames transmitted on this port.
This field shows the number of pause frames transmitted on this port.
This field shows the number of frames received on this port.
This field shows the number of multicast frames received on this port.
This field shows the number of broadcast frames received on this port.
This field shows the number of pause frames received on this port.
This field shows the number of control frames received on this port.
This field shows the number of times one collision occurred before a frame could be
transmitted successfully on this port.
79.
for more information about STP.
for more information about LACP.
MS-7206 User's Guide