Link Aggregation; Figure 42 Link Aggregation; Table 35 Link Aggregation - ZyXEL Communications MS-7206 User Manual

20.4 Link Aggregation

Use this screen to configure trunk groups on the switch. See
information on link aggregation. To open this screen, click Advanced Application > Link
Aggregation > Configuration.

Figure 42 Link Aggregation

The following table describes the labels in this screen.

Table 35 Link Aggregation

LABEL
Active
System
Priority
MS-7206 User's Guide
DESCRIPTION
Select this to enable Link Aggregation Control Protocol (LACP).
LACP system priority is a number between 1 and 65,535. The switch with the lowest
system priority (and lowest port number if system priority is the same) becomes the
LACP "server". The LACP "server" controls the operation of LACP setup. Enter a
number to set the priority of an active port using Link Aggregate Control Protocol
(LACP). The smaller the number, the higher the priority level.
Chapter 20 Link Aggregation
Section 20.1 on page 111 for more
113