Ospf Configuration - ZyXEL Communications MS-7206 User Manual

Table 60 OSPF Status: Common Output Fields (continued)
FIELD
Backup
Designated
Router
Time Intervals
Configured
Neighbor Count
Adjacent
Neighbor Count
Neighbor
Neighbor ID
Pri
State
Dead Time
Address
Interface
Link State
Database
Link ID
ADV Router
Age
Seq #
Checksum
Link Count

30.3 OSPF Configuration

Use this screen to activate OSPF, set general settings, and configure areas. See
page 161 for more information on OSPF. To open this screen, click IP Application > OSPF >
Configuration.
MS-7206 User's Guide
DESCRIPTION
This field displays the router ID of a backup designated router.
This field displays the time intervals (in seconds) configured.
This field displays the number of neighbor routers.
This field displays the number of neighbor router(s) that is adjacent to the switch.
This field displays the router ID of the neighbor.
This field displays the priority of the neighbor. This number is used in the
designated router election.
This field displays the state of the neighbor (backup or DR (designated router)).
This field displays the dead time in seconds.
This field displays the IP address of a neighbor.
This field displays the MAC address of a device.
This field displays the ID of a router or subnet.
This field displays the IP address of the layer-3 device that sends the LSAs.
This field displays the time (in seconds) since the last LSA was sent.
This field displays the link sequence number of the LSA.
This field displays the checksum value of the LSA.
This field displays the number of links in the LSA.
Chapter 30 OSPF
Section 30.1 on
165