Endress+Hauser Levelflex FMP56 Operating Instructions Manual page 30

Installation
30
5. Saw off the rope at a right angle or cut it off with a bolt cutter.
6. Insert the rope completely into the weight.
7. Screw the setscrews back into place. Due to the clamping coating of the setscrews, it
is not necessary to apply a locking compound.
Entering the new probe length
After shortening the probe:
1. Switch to the Probe settings submenu and perform a probe length correction.
2.
1 Field for the new probe length
For documentation purposes, enter the new probe length into the quick reference
guide which can be found in the electronics housing behind the display module.
6.2.3 Mounting the device
Mounting devices with a threaded connection
Levelflex FMP56, FMP57 HART
1
A0014241
A0012528
Endress+Hauser