Operation - Icom IC-775DSP Instruction Manual

W Channelized split operation
@ Set the receive frequency.
frequency.
- The transmit and receive frequencies are equalized.
aw, wm a, m VFO VFO e ES
$ " blinks.
Shows the shift frequency.
@ Push SUB [M-CH 'UP]/[M-CH DN] one or more
- The frequency step is equal to the split shift fre-
quency.
See the previous section for programming.
- Rotate the sub dial to adjust the transmit frequency.
- The transmit frequency can be monitored while
pushing [XFC] or using dualwatch.
© Push [SPLIT] twice to cancel the function.
- The SUB readout frequency disappears and the split
:
'
' frequency operation is turned OFF. i
PRACTICAL EXAMPLE
PRACTICAL EXAMPLE
PRE-OPERATION
@ Cancel the split shift frequency.
- Push MAIN [F-INP}, {0}, [SPLIT].
PRE-OPERATION
@ Program 10 kHz for the split shift frequency.
- Push MAIN [F-INP], [1], [0], [SPLIT].
@ Program 5 kHz for the [A UP]/[ 7 DOWN] switches.
- Push MAIN [F-INP], ISL [UP].
OPERATION
@ Announce your receive frequency; then, push [SPLIT]
for 2 sec.
-The
SUB readout frequency
is equalized
to the MAIN
readout frequency and they appear with "SPLIT."
@ Rotate the main dial to set your receive frequency in
the MAIN readout.
@ After you catch one of the calling stations' call signs,
push and hold the PTT switch to respond.
- While pushing [XFC], you can monitor your transmit fre-
quency.
OPERATION
@ When the DX station says "up 10 kHz":
Push [SPLIT] for 2 sec. only.
@ When the DX station says "up 15 kHz":
Push [SPLIT] for 2 sec., then, while pushing [XFC],
push [A UP].